Delta TP305 Instruction Manual download pdf (Page 12)

CARRYING HANDLE/STOCK

TRANSFER BAR

1. Your planer is provided with a foam covered carrying

handle (A) Fig. 17, located on top of the machine, for

ease in transporting the planer.

2. The carrying handle (A) Fig. 18, also doubles as a

stock transfer bar for transferring stock from the

outfeed to infeed end of the machine. This is helpful

when planing long material, as the workpiece can

easily be transferred back to the infeed end of the

machine for additional cuts.

REPLACING KNIVES

The knives supplied with your planer are double edged

and reversible, which enables you to turn the knives

end-for-end when one edge becomes dull or chipped. To

change the knives, proceed as follows:

Disconnect tool from power source.

1. Raise head assembly all the way to the top.

2. Remove cutterhead guard (B) Fig. 19 by removing

two knobs, one of which is shown at (A).

The knives are sharp. Be careful when

removing, handling or installing knives.

3. Using the supplied wrench (E) Fig. 20, unscrew the

six screws at (F), only enough until locking bar (D)

separates from knife, allowing knife to be removed.

Fig. 17

Fig. 19

Fig. 20

Fig. 18

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

No comments

Delta TP305 Instruction Manual Page 12