Delta 36-412 Service Manual download pdf (Page 24)

--- 20 ---

(4) Setting to cut crown moldings at positions and in Fig. 25 (See Fig. 31; tilt the head to the right.):

Turn the turn table to the left and set the miter angle as follows:

For 45˚ type crown moldings: 35.3˚ ( mark)

For 38˚ type crown moldings: 31.6˚ ( mark)

Tilt the head to the right and set the bevel angle as follows:

For 45˚ type crown moldings: 30˚ ( mark)

For 38˚ type crown moldings: 33.9˚ ( mark)

Position the crown molding so that the lower surface ( in Fig. 24) contacts the fence as indicated in

Fig. 33.

(3) Setting to cut crown moldings at positions and in Fig. 25 (See Fig. 30; tilt the head to the right.):

Turn the turn table to the right and set the miter angle as follows:

For 45˚ type crown moldings: 35.3˚ ( mark)

For 38˚ type crown moldings: 31.6˚ ( mark)

Tilt the head to the right and set the bevel angle as follows:

For 45˚ type crown moldings: 30˚ ( mark)

For 38˚ type crown moldings: 33.9˚ ( mark)

Position the crown molding so that the lower surface ( in Fig. 24) contacts the fence as indicated in

Fig. 32.

3 B

Head

Miter angle scale

Bevel angle scale

Fig. 30

2 3

Fig. 31

Bevel angle scale

Turn table

Fence (A)

Miter angle scale

Fig. 32

Fig. 33

Fence

Table on base

Fence

Table on base

Base

Turn table

Base

Head

Fence (B)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 75 76

No comments

Delta 36-412 Service Manual Page 24