Delta 36-412 Service Manual download pdf (Page 37)

--- 33 ---

(f) Remove the two Hex. Socket Hd. Bolts M6 x 20 [44] to remove the Laser Holder Ass'y [83].

(g) Remove the Split Pin D2 x 12 [3] with long-nose pliers. Loosen the Special Bolt M5 [8] and lightly tap the Roll

Pin D3 x 14 [5] with a hammer to remove it. Then the Laser Base Ass'y [10], two Springs (C) [6], Laser

Holder (A) [2], Laser Holder (B) [4] and Laser Module (A) [14] can be removed.

(h) Turn Laser Module (A) [14] mounted to Laser Holder (A) [2] counterclockwise to remove Laser Module (A)

[14] from Laser Holder (A) [2].

NOTE: Before mounting Laser Module (A) [14] to Laser Holder (A) [2], apply Super X No. 8080 (Cemedine

Co., Ltd.) to the threaded portion of Laser Holder (A) [2].

2. Removal of Spring (A) [42]

(a) After the above steps from 1-(a) to (f), remove the Hex. Socket Hd. Bolt M6 x 16 [245].

NOTE: Note that the Gear Case [246] moves upward when the Hex. Socket Hd. Bolt M6 x 16 [245] is

removed because the Hex. Socket Hd. Bolt M6 x 16 [245] acts as an upper limit stopper of the Gear

Case [246].

(b) Remove the Seal Lock Hex. Socket Set Screw M6 x 10 [40]. Holding the Gear Case [246], slightly tap Shaft

F. Vise ass'y

Tool required:

• Phillips screwdriver

Fig. 47

1. Remove the Wing Bolt M6 x 15 [136] to remove the Vise Shaft [141].

2. Remove the Machine Screw M4 x 10 [140] to remove the Vise Plate [139].

3. Remove the Knob Bolt [135] from the Screw Holder [137].

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 75 76

No comments

Delta 36-412 Service Manual Page 37