Delta 36-412 Service Manual download pdf (Page 44)

--- 40 ---

11-5. No-load Current

After no-load operation for 30 minutes, the no-load current values should be as follows.

11-6. Reassembly Requiring Adjustment

(1) Adjustment of squareness between the saw blade (dummy disc) and the fences

Voltage, frequency

No-load current

120 V

7.9 0.5 A

After disassembly or replacement of the Base Ass'y [167],

Turn Table Ass'y [108], Fence (A) [172], Fence (B) [150] or

Hinge Ass'y [43], it is necessary to perform necessary

adjustment to ensure that the fences are positioned at precise

right angles with relation to the saw blade (or dummy disc).

Align fence (B) with the saw blade (or dummy disc), and adjust

them as necessary to ensure squareness (tolerance: 100 mm).

As shown in Fig. 55, use a square to adjust fence (B) so that it

is square with the saw blade. Next, use a straight edge to

adjust fence (A) so that it is exactly aligned with fence (B).

Finally, use the square to confirm squareness of fence (A) with

the saw blade (tolerance: 0.4/100 mm).

(2) Reassembly of the Turn Table Ass'y [108]

When reassembling the Turn Table Ass'y [108]

and the Base Ass'y [167], tighten the Nylon Nut

M8 [104] so that the Turn Table Ass'y [108] turns

smoothly without excessive play or vibration.

During reassembly, liberally apply grease (Hitachi

Motor Grease) at the point marked "A" in Fig. 56.

Fig. 56

Fig. 55

[150]

[172]

Nylon Nut M8 [104]

Shaft (B) [168]

Base Ass'y [167]

Turn Table Ass'y [108]

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

No comments

Delta 36-412 Service Manual Page 44