Delta BS150LS Instruction Manual download pdf (Page 8)

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is

completely assembled and you read and understand the entire instruction manual.

STAND ASSEMBLY

1. Assemble stand as shown in Fig. 4, using parts

shown in Fig. 3. The brackets and legs are identified

with the same letter in both illustrations. Insert the

M8 x 16mm carriage head screws through the legs

and the brackets then place the 3/8" flat washers

followed by M8 lock washers on the screws and

secure with the M8 hex nuts. Only tighten nuts finger-

tight at this time. NOTE: The top lips of top brackets

(A) must fit on top of the front and back brackets

(B).

2. Attach the four plastic feet (1) Fig. 4 to the bottom of

each leg (L).

BAND SAW TO STAND ASSEMBLY

1. Fig. 5 illustrates the four through holes (A) which will

be used to secure the band saw to the stand.

2. Place the band saw on top of the stand and line up

the holes (A) Fig. 5 with the holes (D) Fig. 6 on the

top brackets of the stand.

Fig. 6

Fig. 4

Fig. 5

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 2 to 3 hours.

1. 3mm Hex Wrench - provided 4. M8 Socket - not provided

2. 4mm Hex Wrench - provided 5. M8 Wrench - not provided

3. 5mm Hex Wrench - provided

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from

unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.

Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your

machine.

After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 71 72

No comments

Delta BS150LS Instruction Manual Page 8