Delta Sidekick 36-210 Instruction Manual download pdf (Page 19)

Fig. 46

Fig. 47

CHANGING THE BLADE

WARNING: USE ONLY CROSS-CUTTING SAW

BLADES. WHEN USING CARBIDE TIPPED BLADES,

MAKE SURE THEY HAVE A NEGATIVE HOOK ANGLE.

DO NOT USE BLADES WITH DEEP GULLETS AS

THEY CAN DEFLECT AND CONTACT GUARD. USE

ONLY 10" DIAMETER SAW BLADES RATED FOR 5500

RPM OR HIGHER WITH 5/8" ARBOR HOLES.

1. DISCONNECT THE MACHINE FROM THE POWER

SOURCE.

2. Remove screw (A) Fig. 47.

MAINTENANCE

CONSTRUCTING WORK SUPPORT EXTENSIONS

One of the unique features of your miter box is the ease with which you can construct work

supports. Fig. 46, illustrates the miter box mounted to two standard 2 x 4’s (A). Fasten the

grooves in the four mounting legs, two of which are shown at (B), to the 2 x 4’s using four

screws through the four holes in the mounting legs. The length of the 2 x 4’s (A) can vary

depending on your preference. The distance from the top of the 2 x 4’s (A) to the compound

miter box table is 3-1/2 inches. This enables you to fasten standard 2 x 4’s (C) to the top of the

2 x 4’s (A), as shown. The top of the 2 x 4’s (C) will then be the same height as the miter box

table. This method allows you to provide support for long work-pieces using standard 2 x 4’s

instead of constructing an expensive, complicated work support.

1 2 ... 14 15 16 17 18 19 20

No comments

Delta Sidekick 36-210 Instruction Manual Page 19