Delta 36-841 User Manual download pdf (Page 24)

Fig. 84

Fig. 86

Fig. 85

USING THE FENCE AS A

CUT-OFF GAGE

WARNING: WHEN USING YOUR UNIFENCE AS A

CUT-OFF GAGE, MAKE SURE IT IS PROPERLY SET

UP AS DESCRIBED HERE.

The fence can be used as a cut-off gage when cross

cutting a number of pieces to the same length.

IMPORTANT: When using the fence as a cut-off gage, it

is very important that the rear end of the fence be

positioned so the work piece is clear of the fence before

it enters the blade. When using the fence as a cut-off

gage, position the fence (A) to the front as shown in Fig.

84, or purchase a 12" long fence (B), as shown in Fig. 85.

A typical operation using the 12" long fence (B) as a cut-

off gage is shown in Fig. 86.

USING AUXILIARY WOOD

FACING ON THE UNIFENCE

Fig. 87

It is necessary when performing special operations such

as when using the moulding cutterhead to add wood

facing (A) Fig. 87, to one side of the rip fence as shown.

The wood facing is attached to the fence with wood

screws through holes you drill in the fence. A suitable

stock size for most work is 3/4", although an occasional

job may require one inch facing.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

No comments

Delta 36-841 User Manual Page 24