Delta 11-985 Instruction Manual download pdf (Page 7)

Fig. 11

Fig. 12

Fig. 13

Fig. 14

7. Figure 11, illustrates the table raising and lowering

handle (K) assembled to worm gear shaft (G).

8. Thread table clamp (M) Fig. 12, into hole in rear of

table bracket, as shown.

9. Place the drill press head (N) Fig. 13, onto the

column as far as it will go. Line up drill press head with

base and tighten two screws (0) with wrench provided.

10. Thread the three pinion shaft handles (P) Fig. 14, into

the three tapped holes located in the pinion shaft, as

shown.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Delta 11-985 Instruction Manual Page 7