Delta 36-650 Instruction Manual download pdf (Page 8)

ASSEMBLY

STAND LEGS

1. Assemble the longer bottom bracket (A) Fig. 6, to

the inside of two table legs (B) as shown. Align the holes

in the longer bottom bracket (A) Fig. 6, with the holes in

the table legs (B). Insert a 5/16-18x5/8" carriage head

bolt through the hole in the table leg (B) and the hole in

the longer bottom bracket (B), place a 5/16" flat washer

onto the carriage head bolt, place a 5/16" lockwasher

onto the carriage head bolt, thread a 5/16-18 hex nut

onto the carriage head bolt. NOTE: Only snug-up stand

mounting hardware at this time. Repeat this process for

the three remaining holes in the larger bottom bracket.

2. Assemble the other stand bracket (A) Fig. 6, to the

remaining two table legs (B) in the same manner.

3. Assemble the two shorter stand brackets (D) Fig. 7,

to the leg assemblies (B) in the same manner as the

longer bottom bracket was assembled.

4. Assemble a rubber foot (E) Fig. 7, to the bottom of

each leg as shown.

Fig. 6

Fig. 7

Fig. 8

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE

INSTRUCTION MANUAL.

Fig. 9

STAND TO SAW

TO PREVENT PERSONAL INJURY OR

DAMAGE TO THE MACHINE, WE SUGGEST THAT THE

STAND BE MOUNTED TO THE SAW AS FOLLOWS:

1. Place the saw upside down on a sturdy work bench

or floor as shown in Fig. 8. TO PROTECT

THE TABLE TOP, PLACE SOMETHING BETWEEN

THE TABLE TOP AND THE WORK BENCH OR

FLOOR, SUCH AS A PIECE OF CARDBOARD,

CARPET ETC. NOTE: Make certain the shorter stand

brackets (D) Fig. 8, are at the front and rear of the saw

as shown.

2. Align the eight holes in the bottom of the saw

cabinet with the eight holes in stand legs. Place a 5/16"

flat washer onto a 5/16-18x5/8" hex head screw. Insert

the hex head screw through the hole in the saw cabinet

and the hole in the stand leg. Place a 5/16" flat washer

onto the hex head screw, place a 5/16" lockwasher onto

the hex head screw, thread a 5/16-18 hex nut onto the

hex head screw. NOTE: Only snug-up stand mounting

hardware at this time. Repeat this process for the five

remaining holes in the saw cabinet and the stand legs.

3. Assemble bracket (H) Fig. 9, to the inside of front leg

assembly (D) as shown. Align holes in bracket (H) with

holes in front leg assembly (D). Place a 5/16" flat washer

onto a 5/16-18x5/8" hex head screw. Insert the hex

head screw through the hole in the saw cabinet, stand

leg, and bracket (H). Place a 5/16" flat washer onto the

hex head screw, place a 5/16" lockwasher onto the hex

head screw, thread a 5/16-18 hex nut onto the hex head

screw. NOTE: Only snug-up stand mounting hardware

at this time.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments

Delta 36-650 Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Delta 36-650