INSTRUCTION MANUAL10" Variable Speed Drill Press(Model DP250)PART NO. 906771 - 07-01-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 17To learn
1010. IMPORTANT: Make certain the spindle taper (Q) Fig.15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rust preventive
11Fig. 18AFLEXIBLE LAMPThe flexible lamp operates independently of the drillpress. To turn the lamp “ON” and “OFF”, rotate switch(A) Fig. 18A.WARNING:
12VARIABLE SPEED CONTROLIMPORTANT: To avoid damaging the drive belts andpulleys, DO NOT turn speed control handles (A) Fig. 24,unless motor is runnin
13ADJUSTING SPINDLERETURN SPRINGThe spindle is automatically returned to its upper mostposition when the handle is released. It is recommendedthat the
14INSTALLING ANDREMOVING DRILL BITS1. DISCONNECT MACHINE FROM POWER SOURCE.2. Insert smooth end of drill bit (A) Fig. 29, into chuck(B), as far as it
15LUBRICATION1. DISCONNECT MACHINE FROM POWER SOURCE.2. Remove the six screws (A) Fig. 30 that hold the topcover in place, and remove the top cover. 3
Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
3ADDITIONAL SAFETY RULES FORFOR DRILL PRESSES1. DO NOT OPERATE THIS TOOL UNTIL it isassembled and installed according to theinstructions.2. OBTAIN ADV
4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a
6DRILL PRESS PARTSFig. 1Fig. 11 - Drill Press Head and Motor2 - Column, Base Flange, and Rack3 - Table4 - BaseFig. 25 - Chuck6 - Clamp Handle7 - Pinon
7ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERS
84. Slide raising rack (F) Fig. 7, table and table bracketonto drill press column, as shown. Make sure bottom ofraising rack (F) Fig. 8, is inside the
97. Thread stud on clamp handle (M) Fig. 12, into hole inrear of table bracket, as shown.8. Place the drill press head (N) Fig. 13, onto thecolumn as
Comments to this Manuals