Delta ts200ls Instruction Manual download pdf (Page 17)

RIP FENCE OPERATION

AND ADJUSTMENTS

1. To move the rip fence (A) Fig. 33 along the table, lift

up the fence locking lever (B), slide the fence to the

desired location on the table, and push down the

fence locking lever (B).

2. The pointer indicates the distance from the fence to

the saw blade. If an adjustment is required, loosen

the screw (C) Fig. 37 and adjust.

IMPORTANT: The rip fence must be properly aligned

to the miter gauge slot to prevent kickback when

ripping.

3. The saw blade is set parallel to the miter gauge slot

at the factory. The fence must be parallel to the miter

gauge slot to do accurate work and to prevent

kickback when ripping. To check the alignment:

4. Position the fence next to the miter gauge slot (Fig.

33). Clamp the fence to the table by pushing the

locking lever (B) down . The edge of the fence should

be parallel to the miter gauge slot.

Fig. 33

TABLE INSERT ADJUSTMENT

1. Make sure that the table insert (A) Fig. 33A, is flush

with, or slightly below, the surface of the table (B).

2. If the table insert is above the surface of the table,

tighten the two table insert screws (C) Fig. 33A to

lower the insert.

Fig. 33A

6. If an adjustment is necessary, loosen the two

screws (D) Fig. 33, and lift the locking lever (B).

While holding the fence bracket (F) firmly toward

the front of the saw, move the rear of the fence (A)

until it is parallel with the miter gage slot. Tighten

two screws (D) and push locking lever down (B).

7. Adjust the clamping action of the fence (A) Fig. 33

by lifting the locking lever (B) and turning the screw

(E) clockwise to increase, or counterclockwise to

decrease the clamping action of the fence.

DISCONNECT MACHINE FROM POWER

SOURCE.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

No comments

Delta ts200ls Instruction Manual Page 17