Delta 32-326 Instruction Manual download pdf (Page 18)

Fig. 46

Fig. 47

Fig. 48

Fig. 49

STARTING AND

STOPPING MACHINE

(For 32-326 Pneumatic Line Boring Machine

Only)

1. Plug the motor cord (A) Fig. 46, into outlet (B) located

on rear of the air and electric control box as shown.

LOWERING BORING HEAD

(For 32-325 Line Boring Machine Only)

To lower the boring head (A) Fig. 49, pull down on handle

(B). After holes have been bored, return handle to the up

position.

2. Move the motor on-off switch (C) Fig. 47, to the

“ON” position. The motor will not start at this time.

MAKE SURE THE AREA UNDER THE

HEAD IS FREE OF ALL OBSTACLES AND HANDS

BEFORE PRECEDING TO THE NEXT STEP.

3. Press in and hold the start button (D) Fig. 47. This will

start the machine and begin the operating cycle of the

boring head. At completion of the operating cycle, the

machine will shut off and you can release the start button

(D). If you release the start button (D) at any time during

the operating cycle, the motor will shut off and the boring

head will return to the up position.

4. If the motor does not start, press the reset button (E)

Fig. 47. If the machine still does not start, refer to section

“ADJUSTING AIR PRESSURE.”

DO NOT USE THIS RECEPTACLE

OUTLET (B) FIG. 46, FOR ANY OTHER ELECTRICAL

USE OTHER THAN THE UNIT MOTOR.

LOCKING SWITCH

IN THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch

should be locked in the OFF position using a padlock (A)

Fig. 48, with a 3/16" diameter shackle to prevent

unauthorized use.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Delta 32-326 Instruction Manual Page 18