Delta 36-714B Instruction Manual download pdf (Page 10)

Align the three holes in the left extension wing with the three holes

(A) Fig. 9 in the side of the saw table. Place a 7/16" lockwasher

and a 7/16" flat washer on a 7/16-20 x 1-1/4” hex head screw

(B) Fig. 9. Insert the screw through the hole in the extension wing

and thread the screw into the tapped hole in the side of the table.

Repeat this process for the two remaining holes in the extension

wing and saw table.

Use a straight edge (E) Fig. 11 to level the extension wing with

the saw table before tightening the three bolts (B) Fig. 10. Use an

18mm open-end wrench and start with a bolt on one side. Align

the table and wing and tighten that bolt. Move to the middle bolt

and follow the same procedure. Finish with the bolt on the other

end.

NOTE: Ensure that the front edge of the wing is flush with or slightly behind the front edge of the table.

Place the right extension wing on the other side of the saw in the same manner.

Do not operate the saw without right table wing installed.

HOW TO ATTACH THE EXTENSION WINGS

Disconnect the machine from the power source!

Fig. 9

Fig. 10 Fig. 11

HOW TO INSTALL THE SWITCH

Disconnect the machine from the power source!

Fig. 12

Attach the switch behind the table edge with the hardware

(supplied with the fence). The screw that fastens the front

fence rail will secure the switch by going though the hole (A)

Fig. 12 in the table edge and the hole (B) in the switch.

Fig. 12

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

No comments

Delta 36-714B Instruction Manual Page 10