Delta 37-071 Instruction Manual download pdf (Page 9)

UNPACKING

FENCE ASSEMBLY

1. Attach the fence support bracket (A) to the tool

frame using two M8 x 25mm socket head screws

(B), each fitted with an 8mm lock washer. See

Figure 1. Ensure that the top surface of the bracket

is flush with the top of the table.

2. Referring to Figure 2, slide the dovetail clamp (C)

onto the fence support (D) ensuring the tops of both

bottom pins in the clamp are flush with the bottom

surface of the fence support bracket. Loosely

secure the dovetail clamp to the fence support with

the indexing lock handle (E).

3. Attach the fence mounting plate (A) to the fence

(B) using four M8 x 25mm socket head screws and

8mm lock washers. See Figure 3.

4. Slide assembled fence (A) over the fence support

bracket (B). The left edge of the fence assembly

should be aligned with the left edge of the

bracket. The dovetail edge on the right side must

be engaged with the dovetail clamp. Tighten the

indexing lock handle to firmly secure and square the

assembly. Insure that the red sliding guard moves

freely and attaches to the magnets on the rear side

of the fence. See Figure 4.

FIGURE 1

ASSEMBLY

FIGURE 2

Remove any protective materials and coatings from all of the parts and the tool. The protective coatings can be

removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before

all of the protective coatings are removed completely.

If any parts are missing, do not attempt to plug in the power cord and turn “ON” the machine. The

machine should only be turned “ON” after all the parts have been obtained and installed correctly.

FIGURE 3

FIGURE 4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

No comments

Delta 37-071 Instruction Manual Page 9