Delta ts200ls Instruction Manual download pdf (Page 11)

Fig. 5

Fig. 6

Fig. 7

ATTACHING BLADE HEIGHT ADJUSTING HANDWHEEL

1. Insert an M6x1x55mm pan head screw (D) Fig. 5 through the handle (E). Attach the handle (E) to the handwheel (A)

by threading the screw (D) clockwise into the handwheel.

2. Attach the handwheel (A) Fig. 6 to the shaft (B). Align the flat on the inside of the handwheel to the flat on the shaft.

3. Fasten the handwheel (A) Fig. 7 to the shaft using an

M6x1x12mm flat head screw (C)

DISCONNECT MACHINE FROM POWER

SOURCE.

PROPERLY ALIGN THE BLADE GUARD

AND SPLITTER ASSEMBLY WITH THE

SAW BLADE TO PREVENT KICKBACK.

1. Position the blade 90 degrees to the table and lock

in place.

2. Fasten the splitter support bracket (A) Fig. 9 to the

splitter bracket (B) using two 1/4-20x1/2" hex head

screws (C) and two 1/4" external tooth lockwashers

(D).

NOTE: Loosely tighten the screws for further

adjustment.

Fig. 9

ATTACHING BLADE GUARD AND SPLITTER ASSEMBLY

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

No comments

Delta ts200ls Instruction Manual Page 11