Delta 28-348 Instruction Manual download pdf (Page 10)

TOP PLATE TO CABINET

NOTE: IF YOUR MACHINE IS SUPPLIED WITH AN

LVC STARTER BOX, PLEASE REFER TO THE

SUPPLEMENTAL INSTRUCTION SHEET FOR

MOUNTING THE LVC BOX TO THE STAND. THEN

PROCEED AS FOLLOWS.

1. Place the top plate (A) Fig. 10, on the top of the

cabinet (B). NOTE: PLACE THE SWITCH CORD (F)

FIG. 10, THROUGH THE SLOTTED HOLE (G) IN THE

TOP PLATE (A) AND INSERT PLASTIC BUSHING (H)

INTO THE SLOTTED HOLE (G).

2. Align the six square holes on the top plate (A) Fig.

10, with the holes in the cabinet (B).

3. Align the two square holes on the side of the plate

(A) Fig. 10, with the two holes on the side of the cabinet

(B).

4. Insert 5/16-18x3/4" carriage head bolts through the

top plate and the cabinet. Thread 5/16-18 flange hex

nuts on to screws.

5. Make sure the door opening is at least 13" wide

before tightening the screws. If the door opening is not

at least 13" wide, spread the door opening and tighten

the hardware when the opening is at least 13" wide.

Fig. 10

DUST CHUTE

1. Insert the dust chute from inside the stand through

the opening (A) Fig. 11, in the top of the stand.

NOTE: MAKE SURE THAT THE MOTOR CORD IS

BEHIND THE DUST CHUTE.

NOTE: MAKE SURE THE TAB (B) FIG. 12, ON THE

DUST CHUTE, ENGAGES THE CUTOUT (C) IN THE

TOP OF THE STAND.

2. Align the two slotted holes (D) Fig. 13, in the bottom

of the dust chute with the two holes (E) Fig. 14, in the

stand.

Fig. 11

Fig. 12

Fig. 14Fig. 13

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Delta 28-348 Instruction Manual Page 10