Delta 28-348 Instruction Manual download pdf (Page 17)

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING SAW

The power switch is located on the left side of the

machine. To turn the machine “ON”, push the green

start button (A) Fig. 41. To turn the machine “OFF”, push

the red stop button (B).

Fig. 41

LOCKING SWITCH IN THE

“OFF” POSITION

IMPORTANT: When the tool is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use, using a padlock (C) Fig. 42 with a

3/16" diameter shackle.

Fig. 42

TILTING THE TABLE

2. The table on the band saw can be tilted 45 degrees

to the right and 9 degrees to the left. To tilt the table to

the right, loosen the two clamp handles (A) Fig. 43, tilt

the table to the desired angle as shown on the scale (D)

Figs. 43 and 44, and tighten two locking handles (A) Fig.

43.

Fig. 43

3. To tilt the table to the left, loosen the two locking

handles (A) Fig. 43, and tilt the table to the right until the

table stops (B) Fig. 44 can be accessed. Rotate the table

stop (B) Fig. 44, and tilt the table to the left. Tighten the

two locking handles (A) Fig. 43.

Fig. 44

DISCONNECT MACHINE FROM

POWER SOURCE.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

No comments

Delta 28-348 Instruction Manual Page 17