Delta 28-348 Instruction Manual download pdf (Page 18)

ADJUSTING THE

TABLE STOPS

2. Loosen the table clamp handles (A) Fig. 43, and tilt

the table to the right.

3. Rotate the stop (B) Fig. 45 out of the way.

4. Place a square (G) Fig. 46, on the table and set

blade square to table.

5. Tighten table clamp handles (A) Fig. 43.

6. Rotate the stop (B) Fig. 45, until the tallest screw is

under the table.

7. Turn the screw up or down until the screw touches

the table skirt.

8. Loosen screw (K) Fig. 47 and move pointer (J) to the

“0”, and tighten screw (K).

To adjust the 90 degree stop

Fig. 45

Fig. 46

Fig. 47

To set the adjustable stops:

2. Loosen the two clamp handles (A) Fig. 43.

3. Tilt the table to the right, and turn the stop until

either stop screw (M) or (N) Fig. 48, is under the table

skirt.

4. Tilt the table to the left until it rests on the selected

stop screw (M) or (N) Fig. 48.

5. The angle can be set by turning the stop screw and

checking the angle on the side of the scale with pointer

(J) Fig. 47.

6. Adjust the other stop screw (M) or (N) Fig. 48, in the

same manner.

Fig. 48

DISCONNECT MACHINE FROM

POWER SOURCE.

DISCONNECT MACHINE FROM

POWER SOURCE.

The adjustable stops (quick stop table presets) can be

used to set the table any where from 0 to 9 degrees left

for beveling operations.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Delta 28-348 Instruction Manual Page 18