Delta 28-348 Instruction Manual download pdf (Page 13)

SAW TO STAND

THE BAND SAW IS VERY HEAVY. USE A

HELPER WHEN ATTACHING THE SAW TO THE

CABINET.

1. Place the band saw on top of the cabinet as shown

in Fig. 23. NOTE: MAKE SURE THE PULLEY (A) FIG.

23, IS ON THE SIDE OF THE CABINET WITH THE

BELT OPENING (B).

2. Align the four holes in the saw with the four holes in

the top of the cabinet.

3. Place 5/16" flat washers on a 5/16-18x1½" hex

head screws. Insert the screws through the holes (C) in

the saw and the cabinet.

4. Thread 5/16-18 hex nuts on the screws and tighten

securely.

Fig. 23

BELT TO SAW AND MOTOR

PULLEY

Fig. 25

MOTOR PULLEY

Fig. 24

NOTE: Both the motor pulley (A) Fig. 24, and the

gearbox pulley (B) are four-step pulleys and should

always be attached inverted to each other.

Check to see if the gear box pulley (B) is attached with

the largest step of the pulley in the “in” or “out” position.

In this case, the largest step of the gear box pulley (B) is

in the “out” position. Attach the motor pulley (A) to the

motor shaft with the largest step of the motor pulley in

the “in” position.

1. Place the 3/4" to 5/8" reducing bushing on the

motor shaft. Align the split in the reducer with the key

way slot.

2. Place the key in the motor shaft.

3. Position the pulley on the shaft. Line it up with the

key. Secure with two 5/16-18x5/16" set screws.

1. DISCONNECT MACHINE FROM POWER

SOURCE.

2. Use a straight edge to align the inside grooves of

the pulleys (A) and (B) Fig. 24 to the inside edge of the

drive pulley (C). The pulleys can be moved in or out on

the shafts and the motor can also be moved.

3. Place the longer V-Belt on the inside groove of the

motor (A) and the drive pulley (C) Fig. 25. Place the

shorter V-Belt on any one of the remaining three grooves

on the motor pulley (A) and the corresponding groove on

the gear box pulley (B). (Fig. 25 shows belts in place.)

4. Adjust the belt tension by raising or lowering the

motor on the motor mounting brackets (A) Fig. 7. Keep

the pulleys in alignment when performing this operation.

Proper tension is 1/4" deflection at the center of the belt

with light finger pressure.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Delta 28-348 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Circular saws Delta 28-348