Delta 36-902 Instruction Manual download pdf (Page 10)

ADJUSTING RAIL STOP

1. The Rail Stop Assembly Fig. 30, can be adjusted to

any number of positions along the guide rail providing a

quick stop setting for the Unifence body by loosening

knob (G) and sliding the stop along the rail to the desired

position and re- tighten.

2. Any number of stops can be purchased and installed

to provide time saving quick stop adjustment for the

Unifence body.

3. If flip stop does not retract fully the bolt (F) Fig. 30,

may have to be repositioned in the rail slot to allow the

flip stop to retract fully. If bolt (F) needs to be

repositioned, just slide the bolt out of the rail and turn the

head of the bolt one third of a turn (one flat) and slide

back into rail, repeat this until the bolt is in the right

position for the flip stop to retract fully. Fig. 31.

Fig. 29

Fig. 30

Fig. 31

ASSEMBLING CURSOR TO

UNIFENCE BODY

1. Remove two screws and flat washers (A) Fig. 32, and

assemble the cursor (B) to the Unifence body (C).

Replace the two screws and flat washers (A).

2. Fig. 33 illustrates the cursor (B) assembled to the

Unifence body. Adjustment to the cursor (B) will be made

later.

Fig. 32 Fig. 33

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Delta 36-902 Instruction Manual Page 10