Delta 36-902 Instruction Manual download pdf (Page 16)

Fig. 54

Fig. 55

Fig. 56

Fig. 58

RIPPING ON LEFT SIDE OF

SAW BLADE

In some cases it may be desirable to use the fence on the

left side of the saw blade. This is accomplished by

repositioning the fence (A) Figures 54 and 55, fence

clamp bar (B) and lock knobs (C) so that the fence (A) will

be attached to the right side of the fence body, as shown

in Fig. 55. The complete fence assembly (D) Fig. 55, can

easily be moved to the left side of the saw table.

USING THE FENCE AS A

CUT-OFF GAUGE

The fence can be used as a cut-off gage when cross

cutting a number of pieces to the same length.

IMPORTANT: When using the fence as a cut-off gage, it

is very important that the rear end of the fence be

positioned in front of the saw blade. When using the

fence as a cut-off gage, simply position the fence (A) to

the front as shown in Fig. 56, or purchase a 12" long

fence (B) catalog # 34-878, as shown in Fig. 57. A typical

operation using the 12" long fence (B) as a cut-off gage

is shown in Fig. 58.

Fig. 57

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Delta 36-902 Instruction Manual Page 16