Delta MS265 Instruction Manual download pdf (Page 13)

If the fence (A) Fig. 22 is removed from the saw, adjust it after replacement so that it is 90 degrees to the blade.

DISCONNECT MACHINE FROM POWER SOURCE.

1. Place one end of the square (B) Fig. 22 against the fence (A) and the other end against the blade (C).

2. To adjust, loosen the four screws (D) Fig. 23 and adjust fence 90° to the blade. Tighten the screws (D).

DISCONNECT MACHINE FROM POWER

SOURCE.

1. The downward travel of the saw blade should be

limited to prevent the saw blade from contacting any

metal surfaces of the machine. This adjustment is

made by loosening the locknut (A) Fig. 24, and

turning the adjusting screw (B) in or out.

2. Lower the blade as far as possible. Rotate the blade

by hand to ensure that the teeth do not contact any

metal surfaces. Adjust if necessary.

3. After the downward travel of the saw blade has been

adjusted, tighten the locknut (A)

ADJUSTING FENCE 90° TO BLADE

ADJUSTING DOWNWARD TRAVEL OF SAW BLADE

Fig. 22

Fig. 23

Fig. 24

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Lower the cutting arm. The saw blade (A) Fig. 21

should be parallel to the left edge (B) of the table

opening.

2. If an adjustment is necessary, loosen two screws (C)

Inset, and move the cutting arm until the blade is

parallel with the left edge (B) of the table opening

and centered in the slot. Then tighten the two

screws (C).

Fig. 21

ADJUSTING BLADE PARALLEL TO TABLE SLOT

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

No comments

Delta MS265 Instruction Manual Page 13