Delta MS265 Instruction Manual download pdf (Page 14)

Fig. 29Fig. 28

DISCONNECT MACHINE FROM POWER SOURCE.

1. Loosen the bevel lock handle and move the cutting arm all the way to the right. Tighten the bevel lock handle.

2. Place one end of a square (A) Fig. 25 on the table and the other end against the blade. Check to see if the blade

is 90° to the table (Fig. 25).

3. If an adjustment is necessary, loosen the locknut (A) Fig. 26. Turn the screw (B) until the head of the screw contacts

the casting (C) when the blade is 90° to the table. Tighten the locknut (B).

ADJUSTING 90° AND 45° BEVEL STOPS

4. Loosen the bevel lock handle and move the cutting

arm all the way to the left bevel position. Tighten the

bevel lock handle.

5. Use a combination square (A) Fig. 27 to see if the

blade is at 45° to the table.

6. If an adjustment is necessary, loosen the locknut (A)

Fig. 28. Turn the screw (B) until the screw (B) contacts

the casting (C) when the blade is 45 degrees to the

table. Tighten the locknut (E).

7. Check to see that the bevel pointer (A) Fig. 29 is

pointing to the 45° mark on the bevel scale. To

adjust the bevel pointer (A), loosen the screw (B) and

adjust the pointer (A). Tighten the screw (B) securely.

Fig. 25

Fig. 26

Fig. 27

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 22 23

No comments

Delta MS265 Instruction Manual Page 14