Delta 32-325 Instruction Manual download pdf (Page 13)

1. Remove the protective cover from the guard.

2. Engage the two slots (B) Fig. 22 on the plastic guard (A) with the two spacers and screws (C) and secure the guard

by tightening the screws.

IMPORTANT: Gently bend the guard (A) outward slightly at the center when installing.

A hole with a rubber grommet (A) Fig. 23 is provided on the top of the machine to store the supplied wrench (B).

ATTACHING THE CLEAR PLASTIC GUARD

WRENCH STORAGE

Fig. 22

Fig. 23

OPERATION

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING THE MACHINE

The on/off switch (A) Fig. 24 is located on the top of the motor. To turn the machine “ON”, move the switch to the “ON”

position.

To turn the machine “OFF”, move the switch (A) to the “OFF” position.

IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position using a padlock (A)

Fig. 25 with a 3/16" diameter shackle to prevent unauthorized use.

LOCKING THE SWITCH IN THE “OFF” POSITION

Fig. 24

Fig. 25

Make sure that the switch is in the “OFF” position before plugging in the power cord. In the event of

a power failure, move the switch to the “OFF” position. An accidental start-up can cause injury.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta 32-325 Instruction Manual Page 13