Delta 32-325 Instruction Manual download pdf (Page 8)

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

5/16" wrench (not supplied)

1/4" wrench (not supplied)

Approximately two hours.

If you purchased the accessory 32-331 steel stand for use with

your boring machine, use Fig. 1 as your guide. Align the holes in

the legs with the holes in the braces, insert a 5/16-18 x 5/8"

carriage bolt through a hole in the leg and the corresponding hole

in the brace. Place a 5/16" flat washer on the carriage bolt and

thread and hand-tighten a 5/16-18 hex nut on the carriage bolt.

Repeat this process for the thirty-one remaining holes.

NOTE: Mount all braces to the inside of the legs.

NOTE: The two top front and rear braces (A) are 13-1/2" long. The

two top side braces (B) are 16-1/2" long. The two bottom front

and rear braces (C) are 19-1/2" long, and the two bottom side

braces (D) are 22-1/2" long. The four legs (E) are 31-1/2" long.

NOTE: Hand-tighten the stand mounting hardware until you

attach the machine to the stand.

Attach the four plastic feet to the bottom of each leg.

ASSEMBLING THE ACCESSORY 32-331 STAND

Place the machine on the stand, using Fig. 2 as a guide.

Align the four holes of the machine with the four holes

on the stand. Insert the 3/4" hex head screw through the

top of the machine and stand. Place a 5/16" flat washer

on the 3/4" hex head screw (A) Fig. 2, followed by a

5/16" Lockwasher. Thread a 5/16-18 nut on the hex

head screw and tighten securely. Repeat this process

for the three remaining holes.

Fig. 1

Fig. 2

ATTACHING THE MACHINE TO THE STAND

If you use the boring machine without the accessory stand, fasten the machine to a stable supporting

surface using suitable hardware (not supplied).

ATTACHING THE MACHINE TO A SUPPORTING SURFACE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Delta 32-325 Instruction Manual Page 8