Delta 32-325 Instruction Manual download pdf (Page 14)

MOVING THE FENCE AND TABLE

DISCONNECT MACHINE FROM POWER SOURCE

You can move the fence and table in or out to bore holes up to four inches from the edge of the workpiece.

Loosen the table lock knobs (A) Fig. 28. Move the table (B) in or out until the index pin (C) Fig. 29 (when pushed down) lines

up with the desired mark on the scale (D). Tighten lock knobs (A) Fig. 28.

Fig. 28

Fig. 29

1. Set the bracket (B) Fig. 27 so that the edge (C) aligns with the “0” mark on the scale.

2. Pull down on the handle (B) Fig. 26. The stop bracket (B) Fig. 27 should contact the stop screw (E) at the same time

that the bits touch the table.

3. If the bits do not touch the table, loosen the stop screw (E) Fig. 27 and adjust the stop screw up or down to just touch

the stop bracket at the same time that the bits touch the table.Tighten the stop screw (E).

ADJUSTING THE STOP SCREW

To lower the boring head (A) Fig. 26, pull down on the

operating handle (B). After the holes have been bored,

return the handle to the “up” position

LOWERING THE BORING HEAD

Fig. 26

You can pull the handle (B) Fig. 26 out to increase the

leverage. Push in on the handle to move it out of the way.

A stop is provided to set the depth of the boring bits. To

control the downward travel of the boring head, loosen the

lock knob (A) Fig. 27, and move stop bracket (B) up or down

until the edge (C) of the stop bracket aligns with the desired

mark on scale (D). Tighten the lock knob (A). A stop screw

(E) is provided to stop the boring head when the bottom of

the stop bracket (B) contacts the stop screw (E). Another

stop, provided on the left side of the machine, ensures an

even depth of cut. Set the right depth stop first. Then lower

the boring head until it contacts the right depth stop and set

the left depth stop accordingly.

OPERATING HANDLE

CONTROLLING THE DOWNWARD TRAVEL OF THE BORING HEAD

Fig. 27

DISCONNECT MACHINE FROM POWER

SOURCE.

DISCONNECT MACHINE FROM POWER

SOURCE.

DISCONNECT MACHINE FROM POWER

SOURCE.

DISCONNECT MACHINE FROM POWER SOURCE.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta 32-325 Instruction Manual Page 14