Delta 32-325 Instruction Manual download pdf (Page 5)

FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.

ADDITIONAL SPECIFIC SAFETY RULES

SAVE THESE INSTRUCTIONS.

Refer to them often and use them to instruct others.

1. DO NOT OPERATE THIS MACHINE until it is

completely assembled and installed according to

the instructions. A machine incorrectly assembled can

cause serious injury.

2. OBTAIN ADVICE from your supervisor, instructor,

or another qualified person if you are not

thoroughly familiar with the operation of this

machine. Knowledge is safety.

3. FOLLOW ALL WIRING CODES and recommended

electrical connections to prevent shock or electrocution.

4. SECURE THE MACHINE TO A SUPPORTING SUR-

FACE. Vibration can cause the machine to slide, walk,

or tip over.

5. NEVER START THE MACHINE BEFORE CLEAR-

ING THE TABLE OF ALL OBJECTS (tools, scrap

pieces, etc.). Debris can be thrown at high speed.

6. NEVER START THE MACHINE with the drill bits

against the workpiece. Loss of control of the

workpiece can cause serious injury.

7. PROPERLY LOCK THE DRILL BITS IN THE CHUCK

before operating this machine.

8. USE ONLY DRILL BITS, with shank size

recommended in your instruction manual. The

wrong size accessory can cause damage to the

machine and/or serious injury.

9. USE ONLY DRILL BITS that are not damaged.

Damaged items can cause malfunctions that lead

to injuries.

10. AVOID AWKWARD OPERATIONS AND HAND

POSITIONS. A sudden slip could cause a hand to

move into the bit.

11. KEEP ARMS, HANDS, AND FINGERS away from

the bit. Serious injury to the hand can occur.

12. TURN THE MACHINE “OFF” AND WAIT FOR THE

DRILL BITS TO STOP TURNING prior to cleaning

the work area, removing debris, removing or

securing work-piece, or changing the angle of the

table. A moving drill bit, cutting tool, or sanding

drum can cause serious injury.

13. PROPERLY SUPPORT LONG OR WIDE work-

pieces. Loss of control of the workpiece can cause

severe injury.

14. NEVER PERFORM LAYOUT, ASSEMBLY OR

SET-UP WORK on the table/work area when the

machine is running. Serious injury can result.

15. TURN THE MACHINE “OFF”, disconnect the

machine from the power source, and clean the

table/work area before leaving the machine. LOCK

THE SWITCH IN THE “OFF” POSITION to

prevent unauthorized use. Someone else might

accidentally start the machine and cause serious

injury to themselves.

16. ADDITIONAL INFORMATION regarding the safe

and proper operation of power tools (i.e. a safety

video) is available from the Power Tool Institute,

1300 Sumner Avenue, Cleveland, OH 44115-2851

(www.powertoolinstitute.com). Information is also

available from the National Safety Council, 1121

Spring Lake Drive, Itasca, IL 60143-3201. Please

refer to the American National Standards Institute

ANSI 01.1 Safety Requirements for Woodworking

Machines and the U.S. Department of Labor OSHA

1910.213 Regulations.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Delta 32-325 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Delta 32-325