Delta 23-710 Instruction Manual download pdf (Page 12)

Fig. 25

USING TOOL AND CHISEL HOLDER

The tool and chisel holder is supplied as standard

equip ment with your sharpening center and is ideal for

sharp en ing wood chisels, plane irons, some lathe turn-

ing tools, etc. To use the tool and chisel holder, proceed

as follows.

1. Loosen the two clamp knobs (A) Figs. 25, 26 and 27,

and insert the tool or chisel between the clamp as

shown, making sure the edge of the tool or chisel

is against the inside of the protractor gage (B). Fig.

25 illustrates a plane iron; Fig. 26 illustrates a wood

chisel; and Fig. 27 illustrates a lathe turning tool in-

serted between the clamp of the tool and chisel

holder. Then tighten the two clamp knobs (A). Adjust

the protractor gage (B) so that the cutting edge of

the tool to be sharpened is the correct angle for the

grinding wheel. Loosen screw (C) Fig. 27, and adjust

the protractor gage (B) as shown. Tighten screw (C)

after angle is obtained.

2. Place the complete tool and chisel holder assembly

(D) Fig. 28, on the tool rest base (E) as shown. Ad-

justment of the tool rest is explained in section “AS-

SEMBLING AND ADJUSTING TOOL AND CHISEL

HOLDER.”

3. Figure 29, illustrates a plane iron being sharpened

using the tool and chisel holder (D) supplied with the

machine.

Fig. 26

Fig. 27

Fig. 28

Fig. 29

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and remov-

ing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

No comments

Delta 23-710 Instruction Manual Page 12