Delta 23-710 Instruction Manual download pdf (Page 20)

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltaportercable.com for a list of service centers or call the

DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

MAINTENANCE

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing

accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp

cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.

FAILURE TO START

Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the

outlet. Also, check for blown fuses or open circuit breakers in the line.

Fig. 63

DRESSING THE DRY GRINDING

WHEEL

A stick type dresser (A) Fig. 63, is supplied with your

sharpening center to dress the dry grinding wheel. Bring

the dresser stick (A) forward on the tool rest until it just

touches the high point of the face of the wheel and dress

the wheel by moving the dresser stick back and forth.

Repeat this operation until the face of the wheel is clean

and the corners of the wheel are square.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

No comments

Delta 23-710 Instruction Manual Page 20