Delta 23-710 Instruction Manual download pdf (Page 17)

Fig. 49 Fig. 50

Fig. 51

Fig. 52

3. Remove sliding tool rest and mounting post (E) Fig.

49, from the wet wheel side of the machine and insert

post of tool rest assembly into hole (F). Tighten screw

(G) into groove (J) of mounting post (E).

4. Fig. 50, illustrates the sliding tool rest (E) assembled

to the dry wheel side of the machine with the knife

holder (H) positioned on the tool rest. All controls and

adjustments for the sliding tool rest are explained in

the section of this manual titled “ASSEMBLING AC-

CESSORY 23-715 SLIDING TOOL REST TO WET

WHEEL.”

5. Fig. 51, illustrates a rough grinding operation on a

planer knife using the dry wheel.

USING THE TOOL REST WITH PLAN-

ER OR JOINTER KNIVES

(E) and carefully slide knife (B) between the top and

bottom pieces (C) and (D) of the sliding tool rest. It is

important that the bevel edge of the knife (B) is in the

down position. Also, be sure the back of the knife is

pushed in so it sits against the knife adjustment bar

inside the tool rest.

2. Make sure knife (B) Fig. 52, pro trudes out from the

top and bottom pieces (C) and (D) of the sliding tool

rest at least 5/16”. If it does not, rotate adjusting

knob (F) Fig. 50, clockwise to move the knife outward

or coun ter clock wise to move the knife in ward. When

moving the knife inward, carefully push the knife (B)

inward with a piece of scrap wood while turning the

knob (F) counterclockwise. When you are certain the

knife pro trudes 5/16” outward from the sliding tool

rest, tighten two screws (E) and four knobs (A).

CARE MUST BE TAKEN WHEN HAN-

DLING PLANER OR JOINTER KNIVES, AS THE CUT-

TING EDGES ARE VERY SHARP. WEAR PROTECTIVE

GLOVES WHEN HANDLING THE KNIVES.

1. Loosen four lock knobs (A) Fig. 52 and two screws

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

No comments

Delta 23-710 Instruction Manual Page 17