Delta 23-710 Instruction Manual download pdf (Page 10)

1. Take the tool and chisel holder base and insert its

mounting post (A) Fig. 11, into hole (B) in the front of

the machine, and tighten screw (C) against groove

(E) of mounting post. Use the provided wrench (D)

Fig. 10.

ASSEMBLING AND ADJUSTING

TOOL AND CHISEL HOLDER

Fig. 13

Fig. 14

2. Loosen screw (C) Fig. 13, move tool and chisel

holder to desired position and tighten screw (C).

3. Place flat washer, spring and another flat washer

onto the tilting screw knob. Thread tilting screw and

spring assembly (H) Fig. 13, into hole in post. NOTE:

End of screw (H) contacts lever (R) and this screw is

used to tilt the tool rest base (J).

4. To level tool and chisel holder base (J) Fig. 13, with

the set grinding wheel (G), loosen screw (F) with

supplied wrench, and turn complete base assembly

(E) until tool and chisel holder base (J) is level with

wet grinding wheel (G), and tighten screw (F).

5. To adjust the height of tool and chisel holder base

assembly (E) Fig. 14, loosen screw (S) and turn ad-

justment knob (T). Tighten screw (S) after height

adjustment is made.

Fig. 11

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Delta 23-710 Instruction Manual Page 10