Delta 23-710 Instruction Manual download pdf (Page 18)

Fig. 49 Fig. 50

Fig. 51

Fig. 52

3. Remove sliding tool rest and mounting post (E) Fig.

49, from the wet wheel side of the machine and

insert post of tool rest assembly into hole (F). Tighten

screw (G) into groove (J) of mounting post (E).

4. Fig. 50, illustrates the sliding tool rest (E) assembled

to the dry wheel side of the machine with the knife

holder (H) positioned on the tool rest. All controls

and adjustments for the sliding tool rest are

explained in the section of this manual titled

“ASSEMBLING ACCESSORY 23-715 SLIDING

TOOL REST TO WET WHEEL.”

5. Fig. 51, illustrates a rough grinding operation on a

planer knife using the dry wheel.

USING THE TOOL REST WITH

PLANER OR JOINTER KNIVES

1. Loosen four lock knobs (A) Fig. 52 and two screws

(E) and carefully slide knife (B) between the top and

bottom pieces (C) and (D) of the sliding tool rest. It is

important that the bevel edge of the knife (B) is in the

down position. Also, be sure the back of the knife is

pushed in so it sits against the knife adjustment bar

inside the tool rest.

2. Make sure knife (B) Fig. 52, protrudes out from the

top and bottom pieces (C) and (D) of the sliding tool

rest at least 5/16”. If it does not, rotate adjusting

knob (F) Fig. 50, clockwise to move the knife

outward or counterclockwise to move the knife in-

ward. When moving the knife inward, carefully push

the knife (B) inward with a piece of scrap wood while

turning the knob (F) counterclockwise. When you are

certain the knife protrudes 5/16” outward from the

sliding tool rest, tighten two screws (E) and four

knobs (A).

CARE MUST BE TAKEN WHEN

HANDLING PLANER OR JOINTER

KNIVES, AS THE CUTTING EDGES ARE VERY

SHARP. WEAR PROTECTIVE GLOVES WHEN

HANDLING THE KNIVES.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Delta 23-710 Instruction Manual Page 18