Delta 23-710 Instruction Manual download pdf (Page 9)

ASSEMBLING AND

ADJUSTING TOOL REST

FOR DRY WHEEL

1. Assemble dry wheel tool rest (A) Fig. 7, to mounting

arm (B) using flat washer (C), lockwasher (D) and

5/8” long hex head screw (E). Place a lockwasher

then a flat washer on the hex head screw, then

assemble tool rest to mounting arm as shown in Fig.

WRENCH HOLDING BRACKET

1. Wrench (D) Fig. 10, can be stored in bracket (A)

when not in use.

2. Figure 8, illustrates dry wheel tool rest (A) assembled

to mounting arm (B). Wrench (F) supplied, is used to

tighten screw (E).

3. The tool rest (A) Fig. 8, is adjustable so the inside

edge of the tool rest can be positioned as close to

the grinding wheel (H) as possible, giving maximum

support to the piece that is being ground. Always

maintain a distance of 1/8” or less between the

grinding wheel (H) and inside edge of tool rest (A). As

the grinding wheel wears down to a smaller

diameter, readjust the tool rest closer to the wheel by

loosening screw (E), moving tool rest (A) inward and

tightening screw (E) using wrench (F). The tool rest

(A) can also be rotated to any desired angle by

loosening screw (E), rotating tool rest (A) and

tightening screw. Rotate dry wheel (H) making

certain wheel does not contact tool rest (A).

Fig. 7

Fig. 8

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Delta 23-710 Instruction Manual Page 9