Delta 23-710 Instruction Manual download pdf (Page 13)

Fig. 25

1. Loosen the two clamp knobs (A) Figs. 25, 26 and 27,

and insert the tool or chisel between the clamp as

shown, making sure the edge of the tool or chisel is

against the inside of the protractor gage (B). Fig. 25

illustrates a plane iron; Fig. 26 illustrates a wood

chisel; and Fig. 27 illustrates a lathe turning tool

inserted between the clamp of the tool and chisel

holder. Then tighten the two clamp knobs (A). Adjust

the protractor gage (B) so that the cutting edge of

the tool to be sharpened is the correct angle for the

grinding wheel. Loosen screw (C) Fig. 27, and adjust

the protractor gage (B) as shown. Tighten screw (C)

after angle is obtained.

The tool and chisel holder is supplied as standard equip-

ment with your sharpening center and is ideal for sharp-

ening wood chisels, plane irons, some lathe turning

tools, etc. To use the tool and chisel holder, proceed as

follows.

USING TOOL AND CHISEL HOLDER

Fig. 26

3. Figure 29, illustrates a plane iron being sharpened

using the tool and chisel holder (D) supplied with the

machine.

2. Place the complete tool and chisel holder assembly

(D) Fig. 28, on the tool rest base (E) as shown.

Adjustment of the tool rest is explained in section

“ASSEMBLING AND ADJUSTING TOOL AND

CHISEL HOLDER.”

Fig. 27

Fig. 28

Fig. 29

OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

Delta 23-710 Instruction Manual Page 13