IQ 100 Series (130/140/150) Meter
Programming the Meter Using the Front Panel
50 User and Installation Manual IM02601003E-September 2011 www.eaton.com
Using the Front Panel
You can access the following modes using the meter’s front panel buttons:
• Operating mode (Default mode)
• Reset mode
• Conguration mode
Use the Menu, Enter, Down and Right buttons to navigate through each mode and its related
screens.
NOTES:
• Appendix A contains the complete Navigation map for the front panel display modes and their screens.
• The meter can also be congured using software (with optional communication); see the next chapter
for instructions.
Understanding Startup and Default Displays
Upon Power Up, the meter displays a sequence of screens:
• Lamp Test screen where all LEDs are lit
• Lamp Test screen where all digits are lit
• Firmware screen showing build number
• Error screen (if an error exists)
After startup, if auto-scrolling is enabled, the meter scrolls the parameter readings on the right side of the
front panel. The Kilo or Mega LED lights, showing the scale for the Wh, VARh and VAh readings. The
gure below shows an example of a Wh reading.
The meter continues to provide scrolling readings until one of the buttons on the front panel is pressed,
causing the meter to enter one of the other modes.
Comments to this Manuals