Delta 100 Series Installation Manual download pdf (Page 73)

IQ 100 Series (130/140/150) Meter

Programming the IQ 100 Series Using Software

73 User and Installation Manual IM02601003E-September 2011 www.eaton.com

• To connect to a location:

a. Select the location you want to connect to from the List of Locations box.

NOTE: You may only connect to one location at a time. To change to a different location, you must

disconnect from the current location by selecting it and clicking Disconnect.

b. Click Connect. When the connection is made, the selected location appears in the Connected To

Locations section of the screen.

c. Click Close. The Device Status screen opens, conrming the connection. The computer Status bar

at the bottom of the screen also conrms the computer’s connection parameters.

NOTE: If the connection fails, a popup screen alerts you. Check that all cables are secure, that the

RS232 cable is connected to the correct Com Port on the computer, and that the computer is set to use

the same baud rate and protocol as the meter to which the computer is connected.

Disconnecting from an IQ 100 Series meter

To disconnect from an IQ 100 Series meter or from a location, do one of the following:

• Click on the Disconnect icon in the Title Bar.

• Select Connection>Disconnect from the Title Bar.

• From the Connection Manager screen, select the location from the Connected to Location eld and

click the Disconnect button.

Changing the Primary Device/Address

Use this feature to select another meter as the primary device.

1. Click Connect>Change Primary Device/Address. You will

see the screen on the right.

2. Enter the address of the device you want to designate as the

new Primary Device.

3. Click OK.

Merging Connection Databases

Use this feature to combine two sets of cnexcom databases.

1. Click Connection>Merge Connection Databases. You will

see the screen on the right. It allows you to select the two

databases to merge.

2. Click the Browse button next to each eld to pick the

databases. The Source cnexcom database will be merged

into the Destination cnexcom database.

3. Click the Merge button to proceed with the merge; click OK

to exit the screen.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 93 94

No comments

Delta 100 Series Installation Manual Page 73