Delta 36-714B Instruction Manual download pdf (Page 18)

ASSEMBLING UNIFENCE

GUIDE RAIL TO TABLE

1. Locate the Guide Rail and mounting hardware from

the packing material of the Unifence.

2. The guide rail has end caps inserted into each end of

the rail. Remove the end cap (B) Fig. 52, by inserting a

flathead screwdriver (C) into the channel in the guide rail

and press outward against the inside of the end cap (B)

as shown. The end cap (B) will pop out. NOTE: Do not

attempt to remove the end cap by forcing the screwdriver

between the end cap and the end of the rail. This will

damage both the cap and the rail.

3. Insert two 3/8-24x1" hex head bolts into the two

holes (F) Fig. 53, in the front of saw table and place flat

washer and nut onto bolt from underneath the saw table.

Screw bolts into nuts two full turns, leaving bolt head

extended approximately 1/2" from the table. Note: Make

sure to use only the two holes shown at (F).

4. Insert two 1/4-20x3/4" hex head bolts (E) Fig. 54 into

the front support of the extension table and place flat

washer and nut onto bolt from underneath the extension

table. Screw bolt into nut two complete turns, leaving bolt

head extended approximately 1/4" from the extension

table.

5. Slide the T-SIot guide rail (A) Fig. 55, onto the hex

head of the bolts partially inserted in steps 3 and 4 above.

Note: The bolt heads on the saw table slide into the

upper t-slot (B) Fig. 55 and the bolt heads on the

extension table slide into the lower t-slot (C) Fig. 56.

6. Slide the guide rail along until the “0” on the Unifence

scale is aligned with the right edge of the saw table. Turn

nuts by hand until they are finger tight.

Fig. 52

Fig. 53

Fig. 54

Fig. 55

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 18