Delta 36-714B Instruction Manual download pdf (Page 9)

LIMITED EDITION UNISAW ASSEMBLY

INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE SAW TO THE POWER SOURCE UNTIL THE

SAW IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLING BLADE

TILTING MECHANISM

HANDLE

1. Install fiber washer (A) Fig. 6A, on the blade tilting

mechanism shaft (B). Install key (C), into shaft keyway.

2. Place handwheel (D) on shaft (B) Fig. 6A. Make sure

the groove (E), in the handwheel lines up with the key (C).

3. Push the handwheel snugly against the fiber washer

and tighten the set screw.

4. Install lock knob (F) Fig. 7, into threaded end of the

shaft (B). Hand-tighten lock knob at this time. (Do not

over tighten - see “Blade Raising Mechinism”)

ASSEMBLING EXTENSION

WINGS

Assemble the extension wings (A) Fig. 8 and Fig. 10, to

the saw table using the six 7/16"-20x1

/4" hex head

screws (B) and 7/16" lockwashers supplied. Use a

straight edge (C) Fig. 9, to make sure the extension wings

(A) are level with the saw table before tightening the

screws (B) Fig. 8 and Fig. 10. NOTE: MAKE SURE

FRONT EDGE OF WING IS FLUSH TO OR SLIGHTLY

BEHIND THE FRONT EDGE OF THE TABLE.

NOTE: When assembling the left extension wing, do

not install the front screw and washer at this time, it

will be installed when assembling the on/off switch.

Fig. 6A

Fig. 7

Fig. 8

Fig. 9 Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 9