Delta 36-714B Instruction Manual download pdf (Page 20)

Fig. 61

Fig. 62

Fig. 63

SETTING FLIP STOP

1. The Flip Stop Assembly Fig. 62, can be set to any

number of positions along the guide rail providing a

quick stop setting for the Unifence body by loosening

knob (G) and sliding the stop along the rail to the desired

position and re- tighten.

2. Any number of stops, Delta Cat. No. 36-899, can be

purchased and installed to provide time saving quick

stop settings for the Unifence body.

3. If flip stop does not retract fully the bolt (F) Fig. 62,

may have to be repositioned in the rail slot to allow the

flip stop to retract fully. If bolt (F) needs to be

repositioned, just slide the bolt out of the rail and turn the

head of the bolt one third of a turn (one flat) and slide

back into rail, repeat this until the bolt is in the right

position for the flip stop to retract fully, as shown in Fig.

63.

Fig. 64

Fig. 65

ASSEMBLING CURSOR TO

UNIFENCE BODY

1. Remove two screws and flat washers (A) Fig. 64, and

assemble the cursor (B) to the Unifence body (C).

Replace the two screws and flat washers (A).

2. Fig. 65 illustrates the cursor (B) assembled to the

Unifence body. The cursor (B) will be adjusted later.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 20