Delta 36-714B Instruction Manual download pdf (Page 28)

ASSEMBLING TABLE LEGS

TO EXTENSION TABLE

IMPORTANT: If your saw will be used with a mobile

base underneath the saw base and table legs, the

position of the legs may have to be changed to fit onto

the mobile base, see Fig. 96.

1. Position the two legs (H) Fig. 97, at the two far

corners of the inside of one end of the extension table, as

shown, and mark the position of the eight holes to be

drilled into the bottom of the table.

Remove the two legs (H) and using a 1/16" drill bit, drill

the eight holes 1/2" deep. Replace the two legs and

fasten to the bottom of the table using the eight 3/4" long

wood screws (I) supplied.

2. Figure 98 illustrates one of the legs (H) fastened to the

bottom of the extension table with the four wood screws

(I). Drill through the two holes (K) and through end piece

(J) of the table with a 1/4" drill bit.

3. Fasten the leg bracket (L) Fig. 99, to the end piece (J)

of the table using the two 1-1/2" long flat head Phillips

screws, flat washers and hex nuts (M) Figs. 98 and 99.

Fasten the remaining leg to the extension table in the

same manner.

Fig. 96

TABLE BOARD HOLE LOCATION FOR SAW WITH

MOBILE BASE

Fig. 97

Fig. 98

Fig. 99

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 28