Delta 36-714B Instruction Manual download pdf (Page 11)

Fig. 16 Fig. 17

Fig. 20 Fig. 21

Fig. 18

Fig. 19

6. Insert threaded end of support rod (G) Fig. 16,

through slot in back of saw and through hole (H) Fig. 16,

in rear trunnion. Fasten support rod (G) Fig. 16, to

trunnion using star washer and 5/8-18 nut (J) Fig. 17.

NOTE: Thread nut (J) onto threaded end of support rod

as far as possible by hand. Using a wrench to hold nut (J)

Fig. 17, tighten rod (G) Fig. 18, using a small screwdriver

(K) or similar device through hole in end of rod (G) as

shown.

7. Assemble lower bracket (L) Fig. 19, to rod (G) and

hand tighten the 2 one inch-long hex head screws (S) and

lockwashers (T), from underneath bracket (L).

8. Assemble splitter bracket (M) Fig. 20, to lower

bracket (L), using one flat washer (P), lockwasher (O), and

one inch-long hex head screw (N). Do not fully tighten

screw (N) at this time.

9. Fasten splitter and guard assembly (P) Fig. 21, to

bracket (M) using one inch-long hex head screw (V) and

flat washer (T).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 11