Delta 36-714B Instruction Manual download pdf (Page 15)

3. Assemble the two table legs (A) Fig. 37 to the bottom

of the table using eight #8x7/8" wood screws.

4. Assemble shelf support bracket (B) Figs. 38 & 51, to

the table legs (A) using two U-clamps (C), 1/4" flat

washers, and 1/4-20 hex nuts. NOTE: Height

adjustments to the bracket will be made later.

5. Insert foot adapter (T) Fig. 39, into the bottom of

each leg (A), using a rubber mallet. Assemble the 3/8"

jam nut (V) approximately 3/4 of the way onto leveling

screw (W). Thread the leveling screw (W) into foot

adapter. Fig. 40 illustrates the foot leveling assembly on

the table leg. Assemble the remaining foot assembly to

the other table leg in the same manner. NOTE: Height

adjustments can be made later.

6. Fasten the front (F) and rear (G) table supports Fig.

41, to the bottom of the table as shown using four

#8x7/8" long wood screws (H) supplied. NOTE: Pilot

holes can be drilled in the particle board using a 1/16"

drill bit, drilling a 1/2" deep, to help attaching the front

and rear table supports.

NOTE: At this time, the screws (H) holding the front

support (F) should not be completely tightened.

NOTE: The slots closer to the angles in the supports (F)

and (G) should be against the table.

NOTE: Do not put fasteners in location (I) at this time.

NOTE: Make certain the ends of the table supports do

not extend out past the table. The rear support (G) Fig.

41, can be fastened to the bottom of the table by

tightening screws (H).

CAUTION: DO NOT OVER-TIGHTEN MOUNTING

SCREWS. Over-tightening screws in particle board may

cause them to strip.

Fig. 37

Fig. 38

Fig. 39

Fig. 40

Fig. 41

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

No comments

Delta 36-714B Instruction Manual Page 15